Post to press F1 solution _ painted roses

Your computer boot time is necessary to press the F1 key to properly enter the system, this is because your BIOS is set incorrectly, but can also be a normal boot system, in the case of non-lethal failures, F1 is asking you whether to continue. Fix post to F1: a: press the Del key, enter BIOS settings, select the first "basic settings", set the floopy a "no" is not valid to Disabel. Two: the first post when you press DEL to enter BIOS, press ENTER to enter the first, a look inside the "DriveA" is not "None", not "Pgup PgDn" "or" be modified, the modified press "ESC" exit, "SaveExitSetup" item press ENTER to exit the BIOS, restart, and then if you change the battery and then follow the steps above to reset. 3: no need to press the F1 key to enter, mainly because the BIOS settings does not match the real hardware data, can be divided into the following cases: 1, virtually no floppy drive or floppy disk drive is broken, and the BIOS is set to the floppy drive, this led to press F1 to continue. 2. the original of the hanging two hard drives in the BIOS is set to double hard drive, then take off one when we forget the BIOS setting to come back, the problem may also occur. 3. motherboard battery has a will result in data loss to occur this failure. 4. reboot the system, enter BIOS settings and found that the floppy was set to 1.44M, but actually there is no floppy drive in the chassis, this key is set to NONE, troubleshooting. There was a lot of people ask this question, here I come across in this type of problem do you want to summarize, we help. HarewareMonitorfoundaner 1, ror, Pfordetails enterPOWERMANAGEMENTSETU, PressF1tocontinue, DELtoenterSETUP Chinese: monitoring features found error, enter detailed information, see POWERMANAGEMENTSETUP press F1 to continue the boot process, press DEL to enter the COMS set. Explanation: some motherboards have hardware monitoring feature, you can set the motherboard and CPU temperature monitor, voltage regulator of voltage output bit monitor and on each fan speed monitoring, when the monitoring features in the find exception when powered on, it will appear above this line, then you can enter the COMS set select POWERMANAGEMENTSETUP, in the right ** FanMonitor **, ** ThermalMonitor ** and ** VoltageMonitor ** view which part issued an exception, and then to be addressed. 2, prislavedrive-ATAPILNCOMPatiblepressF1 toResume might be your CD drive is not connected or has failed, the best in the CMOS will all IDE port is set to automatic. 3. after powering DELtoenterSETUP PressF1tocontinue, press DEL to enter the BIOS, select floppy drive select NONE and press F10 to save on it 4, CMOSchecksumerror-Defaultsloaded PressF1tocontnue? DELtoenterSETUP 08/09/2000-i810-ITE8712-6A69ME1CC-00